Bill of Materials and tools That I used to Build the talKKonnect

Exterior Parts
1. Plastic/Metal housing (The one I used was ABS Plastic 260 x 220 x 100 MM) x 1 
2. Push Button Micro switch (Up/Down Channels) x 2 
3. Eight (8) Pin Panel Mount Microphone Jack x 1
4. Volume (Potentiometer 100KA) x 1
5. Volume Knob x 1
6. Red LED 3mm x 1
7. Green LED 3mm x 1
8. Yellow LED 3mm x 1 
9. Blue LED 3mm x 1
10. LCD Display (20 x 4) 4 Rows HD44780 with Parallel Interface
11. RJ45 female wall socket x 1
12. 3.5mm Mono Panel Mount Jack x 1
13. 6x30 mm Panel Mount Fuse Holder x 1 
14. 1 Amp 250V Fast Blow Glass Fuse x 1
15. 3 Pin SPST Toggle Switch x 2
16. AC Power Cable
Interior Parts
1. Raspberry Pi Model 3 b+ x 1
2. Raspberry Pi Universal Official Power Supply _5.1V 2.5A x 1
3. GOOD 5Hv2 USB Virtual 7.1 Channel 3D Audio External Sound Card Adapter x 1
4. 3.5mm Mono Plug x 2
5. Main Power Transformer 220V to 24-0-24 Volts Center tapped Transformer
6. Electrolytic Capacitor 4700 uF/50V
7. 0.1 uF Ceramic Capacitor x 1
8. TDA2030a mono amplifier Kit x 1
9. Diode 1N4001 x 2 
10. Diode 1N4148 x 1
11. 2SC536 Transistor x 1
12. Resistors 330 Ohms 1/4 Watt 5% for LEDs x 3
13. Resistor 560 Ohms 1/4 Watt 5% for LED x 1
14. Resistor 150 Ohms 1/4 Watt 5% for LED x 1
15. RJ 45 Male Connector + CAT 5e Cable x 1
16. 40 Pin Male 2.54mm spacing single row
Accessories
1. Shrink Tube
2. Electrical Tape
3. Hot Glue Gun
4. Screws & Nuts
5. Metal Standoffs 
6. Colored AWG 22 Wire
7. Colored AWG 24 Wire
8. Shielded Mono or Stereo Cable
9. Cable Ties
10. External Speaker with 3.5mm Mono Plug
11. Solder
12. Solder Flux
13. Female to female jumper wires
Tools
1. Soldering Iron
2. Solder Sucker
3. Hot Glue Gun
4. Drill and Drill Bits of Various Sizes
5. Box Cutters
6. Pliers
7. Screw Drivers
8. Round and Flat Files
Desk Microphone
1. PC Desktop Microphone x 1
2. Plastic Box x 1
3. PTT Micro switch x 1
4. UP/DOWN Micro switch x 2
5. Shielded Cable with 8 Core
6. Eight (8) Pin Microphone plug x 1

Leave a Reply

Your email address will not be published. Required fields are marked *